Device is in Static

Follow the steps below:

1. Connect the PoE injector IN socket directly to your PC

2. Configure the PC in the same range the device is:

   • Go to Network icon, right click and click into "Open Network and Sharing Center"

   • Go to Change adapter settings

   • Right click on the Ethernet Network and go to Properties

• Go to "Internet Protocol Version 4 (TCP /IPv4)" and click properties.

• Once in Properties, you have to set the IP address in the same range as the device

  • For example, if the device has an IP 172.21.0.188, the PC IP address should be 172.21.0.X, where X can go from 1 to 254:

• For example, if the device has an IP 192.168.2.31, the PC IP address should be 192.168.2.X, where X can go from 1 to 254 (excluding 31 and any other IP already in use):

• Open the CMD and try to ping the device to see if there is connection:

• • If there is a response, now you can go to a browser and type the IP address of the device followed by ":3161" and go to the "Network & Time" tab:

• • We recommend to set the method to DHCP and click the "Apply config":

• • Reboot the device and follow the procedure on Discover Devices explained before.