Signal tower
Introduction
Improper use may result in device damage!!
Read this Quick Guide before attempting to install the Tower Signal
This quick guide allows configuring one AdvanSafe unit to a signal tower. This example can be generalized to any Keonn reader or derived systems.
The contents of the guide use as hardware parts:
AdvanSafe
Signal Tower adaptor board
Signal Tower from Auer Signal
Cable with two pairs:
Orange/Black
Red/Brown
We recommend using cables AWG 30 or thicker.
The adaptor board allows to:
Drive the audio device in the signal tower
Drive one and only one light in the signal tower
Connecting the OUT 1 and/or OUT2 to the AdvanSafe/device outputs will result in permanent damage of the IO circuitry of the AdvanSafe unit.
AdvanSafe / AdvanReader connections
The example uses lines 2 and 3 to control the signal tower.
Adaptor board connections
Signal tower connections
AdvanNet configuration
Several configuration may work, this is one possibility. it contains 4 triggers and is designed in a system with:
One AdvanSafe master unit with its internal:
Speaker
LED light
One signal tower connected at out lines 2 and 3
1. Configure the internal light
2. Configure the external signal tower light
In case you a longer duration, you may need to increase the 900 ms to whatever value you prefer.
3. Configure the external sounder
In case you a longer duration, you may need to increase both 900 ms to whatever value you prefer.
4. Configure the internal speaker
